Sony UP-X898MD Instructions For Use Manual page 26

When the message is displayed on the LCD
If a problem occurs, the back light on the LCD lights in
orange and the error message stating the problem is
displayed on the LCD.
Message Cause and remedy
EMPTY:XX Paper is not loaded. Load paper.
DOOR:XX The door is open. Close the door.
XX indicates the selected paper.
"S" means UPP-110S, "HD" means UPP-110HD, and
"HG" means UPP-110HG.
When the unit stops printing
When printing almost black images continuously, the
thermal head protection circuit may shut down the unit
to prevent the thermal head from overheating. In such a
case, the message "COOLING" is displayed on the
LCD.
Leave the unit until the head cools down and this
message disappears.
Paper currently selected
You can check the paper type currently selected on the
LCD. The paper type currently selected is displayed on
the right edge of the LCD when you press the OPEN
button and open the door panel.
UPP-110S
UPP-110HD
UPP-110HG
If the printout image is blurred
A rapidly moving image may be blurred when printed.
Should this occur, make a printout with "-FIELD"
selected in the "FIED:ON" menu item.
Printing images stored in memory
Each time you press the PRINT button, the image is
stored in memory. After 10 images have been stored, the
oldest image data is overwritten with the newest
captured image in sequence.
There are always 10 images stored in memory. You can
load the desired one from among them and print it using
the menu.
1
Select "-PAGE" from among the menu items.
26
Printing
For detailed information on menu operation, see
"Basic Menu Operations" on page 23.
2
Push the menu lever or shift it to the right.
"PAGE:1" is displayed on the LCD.
As the number increases, the image displayed
becomes older.
3
Display the number of "PAGE" that you want to
print by shifting the menu lever up or down.
4
Push the menu lever.
The image selected in step 3 is printed.
Note
The selected image in "-PAGE" cannot be printed by the
COPY button.
Printing two different images on one
sheet
"MLT" selected in "-MULTI" of "VIDEO" allows you
to capture two different images and print them on one
sheet.
1
Select "MLT" in "-MULTI."
The LCD display is changed to the multi picture
mode. "1" flashes.
2
Press the PRINT button in step 3, following the
operations outlined in "Starting a Print Job" on
page 25.
The image displayed at the instant you press the
PRINT button is captured, and the image is
registered to "1." Then, "2" flashes.
3
Press the PRINT button again when the image you
want to print is on the video monitor.
The image is registered to "2," and the printer starts
printing two images on one sheet as follows.
Image captured
in step 2
"INFO:ADJ" is selected in "-INFO" of "PREF.,"
data on the contrast and brightness of the image
captured in step 3 is printed under the image.
Image captured
in step 3