Others; Precautions; Maintenance - Sony UP895 - UP 895 B/W Dye Sublimation Printer Instructions For Use Manual

Precautions

On safety
• Check the operating voltage before operation.
Operate the unit only with a power source specified in
"Specifications".
• Stop operation immediately if any liquid or solid
object falls into the cabinet. Unplug the unit and have
it checked by qualified personnel.
• Unplug the unit from the wall outlet if you will not be
using it for a long time. Disconnect the power cord by
grasping the plug. Never pull the cord itself.
• Do not disassemble the cabinet. Refer servicing to
qualified personnel only.
• Do not touch the cutting blade of the printer.
• Connect the power plug of the printer to a wall outlet
with a protective earth terminal. The safety earth
should be properly established.
On operation
Do not turn the power off while the printer is printing.
The thermal head may be damaged.
On the printer carriage
Do not carry or move the printer when the paper roll is
placed in the printer. Doing so may cause a malfunction.
On installation
• Place the printer on a level and stable surface.
If you use the printer with placed on an uneven
surface, malfunction of the printer is likely to occur.
• Do not install the printer near heat sources. Avoid
locations near radiators or air ducts, or places subject
to direct sunlight or excessive dust, humidity,
mechanical shock or vibration.
• Provide adequate air circulation to prevent heat build-
up. Do not place the printer on surfaces such as rugs,
blankets, etc., or near materials such as curtains and
draperies.
• If the printer is subjected to wide and sudden changes
in temperature, such as when it is moved from a cold
room to a warm room or when it is left in a room with
a heater that tends to produce large amounts of
moisture, condensation may form inside the printer. In
such cases the printer will probably not work properly,
and may even develop a fault if you persist in using it.
If moisture or condensation forms, turn off the power
and allow the printer to stand for at least one hour.

Maintenance

Cleaning the cabinet
Do not use strong solvents to clean the printer. Thinner
or abrasive cleansers will damage the cabinet.
Cleaning the thermal head
If the printout is dirty or white stripes appear on the
printouts, clean the thermal head using the cleaning sheet
supplied .
1
Press the power switch to turn on the printer.
2
Press the OPEN button to open the door.
3
Insert the cleaning sheet, with the black surface
facing down, into the groove in paper tray.
Precautions/Maintenance
Insert into the
groove.
Cleaning sheet
(supplied)
Continue to next page c

Others

31