Operational Description - SMC Networks SMC91C95 Product Manual

OPERATIONAL DESCRIPTION

MAXIMUM GUARANTEED RATINGS*
Operating Temperature Range ...................................................................................... 0
Storage Temperature Range ....................................................................................-55
Lead Temperature Range (soldering, 10 seconds) .................................................................. +325
Positive Voltage on any pin, with respect to Ground ...........................................................Vcc + 0.3V
Negative Voltage on any pin, with respect to Ground .................................................................. -0.3V
Maximum Vcc ............................................................................................................................... +7V
*Stresses above those listed above could cause permanent damage to the device. This is a stress
rating only and functional operation of the device at any other condition above those indicated in the
operation sections of this specification is not implied.
Note: When powering this device from laboratory or system power supplies, it is important that the
Absolute Maximum Ratings not be exceeded or device failure can result. Some power supplies
exhibit voltage spikes on their outputs when the AC power is switched on or off. In addition, voltage
transients on the AC power line may appear on the DC output. If this possibility exists, it is
suggested that a clamp circuit be used.
DC ELECTRICAL CHARACTERISTICS (T
PARAMETER
I Type Input Buffer
Low Input Level
High Input Level
IS Type Input Buffer
Low Input Level
High Input Level
Schmitt Trigger Hysteresis
I Input Buffer
CLK
Low Input Level
High Input Level
o
= 0 C - 70
A
SYMBO MIN TYP
L
V
ILI
V 2.0
IHI
V
ILIS
V 2.2
IHIS
V 250
HYS
V
ILCK
V 3.0
IHCK
104
o
C, Vcc = +5.0 V ± 10%)
MAX UNITS
0.8 V TTL Levels
V
0.8 V Schmitt Trigger
V Schmitt Trigger
mV
0.4 V
V
o o
C to +70 C
o o
C to +150 C
o
C
COMMENTS