Assembling Stand; Mounting Sander To Stand; Handle And Hose Hanger; Folding Infeed/Outfeed Tables (Optional) - Jet JWDS-2244OSC Operating Instructions And Parts Manual

Figure 6-3: Assembly of Sander and OPTIONAL Infeed/Outfeed Tables

6.3 Assembling stand

A closed stand is provided with the JWDS-
2244OSCK Sander kit.
instructions that accompany the stand.

6.4 Mounting sander to stand

The closed stand can be oriented with storage door
toward front or back of machine.
Use an assistant to help lift and
position sander atop stand.
1. Remove any screws holding sander to pallet,
and lift sander from crate.
2. Position sander atop stand so that threaded
holes of base align with holes in stand top.
Insert 6 provided screws and washers and
tighten securely.

6.5 Handle and hose hanger

See Figure 6-3.
1. Install height adjustment handle (B) onto
spindle and tighten set screw.
2. Raise drum using height adjustment handle and
remove shipping block from between drum and
conveyor.
3. Install hose hanger (C) with screws and
washers (C /C ).
1 2
Refer to assembly
6.6 Folding infeed/outfeed tables
(OPTIONAL)
See Figure 6-3.
The sander must be bolted to the stand or a work
table when using these table extensions. Maximum
working load of each table is 35 pounds. Fasteners
are provided with the extension tables.
NOTICE: If using the folding feature of the
infeed/outfeed tables, make sure your table or
bench allows for adequate vertical drop at front and
back.
To install infeed table:
1. Install front (F) fixed bracket to threaded holes
in sander base with screws and washers
(HP4/5). Make sure bracket is oriented as
shown. Bracket must be flush against base.
NOTE: Long bracket mounts to front
(infeed); short bracket to rear (outfeed).
2. Tighten screws (HP4) to secure the brackets.
3. Install eccentric cam (HP8) with screw and
washer (HP6/7). Finger tighten only at this time.
4. Install left (G) and right (H) table brackets, using
handles and washers (HP1/2/3).
Note: Handle (HP1) is adjustable – pull up and
rotate on pin to more convenient position, then
release allowing it to settle back onto pin.
5. Place infeed table (D) onto table brackets and
secure with screws and washers (HP4/5).
Finger tighten only.
9