Table of Contents
Advertisement
6.3 Assembling Stand
(Refer to Figure 6-3. If further clarification is needed,
consult parts breakdown at back of this manual.
1. Assemble legs (F) to outside of Short Rails (D)
using carriage bolts (J) and flanged lock nuts
(K). Finger tighten only.
2. Assemble Long Rail (E) on inside of legs and
on top of Short Rails (D). Finger tighten only.
NOTE: Flange of Long Rail overlaps flange of
Short Rail. See inset, Figure 6-3.
3. Turn stand upside down. Install shelf (C) into
legs using carriage bolts and lock nuts.
4. Fully tighten all flanged lock nuts in shelf and
legs.
5. Insert leveling foot (G) into bottom hole of leg
with flat washers and hex nut.
6. Turn stand right-side up and push down on it to
settle it. Tighten all flanged lock nuts on stand.
7. Level the stand using the leveling feet. Tighten
the hex nuts against the leg flange.
Figure 6-3: Assembly
6.4 Mounting Sander to Stand
1. Lift drum head assembly out of the box, and
temporarily rest it crosswise on top of stand.
the sander.
2. Install height adjustment handle (B) and tighten
set screw.
3. Rotate
counterclockwise to raise drum and free the
wood support block.
4. Position sander atop stand so that the four
threaded holes of base align with holes in the
stand rails (Figure 6).
5. Fasten base to stand (from beneath) with the
four screws and washers.
8
Use an assistant to help lift
height
adjustment
handle
Advertisement
Table of Contents
