Assembly; Stand Assembly - Jet 22-44OSC Operating Instructions And Parts Manual

Assembly

Stand Assembly

1. Position two stand sides (F
ground with the base down, about 3 feet
apart with the openings toward the center.
2. Mount the bottom plate (E) to the stand
sides with four each 5/16" hex cap screws
(L ) and 5/16" flat washers (P
1
tighten only at this time.
3. Secure the left side of the rear plate (G) to
the left stand side (F
hex cap screws (L
2
(P ). Hand-tighten only.
2
F
1
Base
L
P
, F ) on the
1 2
). Hand-
1
) with two each 5/16"
1
) and 5/16" flat washers
1
1
PPPPP
4. Secure the right side of the rear plate (G) to
the right stand side (F
as above. Hand-tighten only.
5. Secure the front plate (H) to the left and right
stand sides (F
above with four each 5/16" hex cap screws
(L) and 5/16" flat washers (P). Hand-tighten
only.
P
2
L
2
G
E
H
Figure 4
9
) in the same manner
2
, F ) in the same manner as
1 2
F
2
Base