Assembly; Install Stand Legs - Jet 22-44 Pro-3 Operating Instructions And Parts Manual

Assembly

Tools required for assembly:
Hoist, forklift, or one or more assistants
Wrenches – 9/32", 1/2" , 9/16"
Hex wrenches – 4mm, 1/8"

Install Stand Legs

The sander is heavy; use
caution when lifting.
1. Raise the sander from the floor using a forklift,
hoist or an assistant. Place hoist straps through
the carriage arm (see Features on page 7) or
below the table mounting brackets. If using a
forklift, place fork below the table mounting
brackets (see Features on page 7).
Referring to Figure 1:
2. Position the assembly fixtures (Z
columns so that the wider part of the
plywood (Z ) faces outward. Lower the sander
2
columns into the assembly fixtures.
3. Mount the four legs (R) to the columns, using
four each 3/8x1-1/2 hex cap screws (A), 3/8 flat
washers (H) and 3/8 flanged lock nuts (E),
Tighten flanged nuts securely with 9/16"
wrench, making sure the legs (R) remain in
contact with the plywood (Z
4. Lift the sander and remove the assembly
fixtures (Z , Z ).
1 2
Referring to Figure 2:
5. With the sander raised, install casters (W) to
legs (R). First lock the caster by pressing the
large tab to remove the hex nut (F) and flat
washer (G).
Table Support Screws
The set-screws on the table supports (Figure 3)
have been tightened at the factory to eliminate free-
play between the table supports and the columns
during shipment. All four set-screws must be
loosened and re-adjusted before operating
either the height adjustment mechanism or the
conveyor drive. Proceed as follows:
Failure to follow the below
procedure may result in misalignment of the
drum and/or conveyor bed, or may damage the
miter gears.
1. Loosen each hex nut with an open-end wrench,
then loosen the set-screw with a hex wrench.
2. Re-tighten the set-screw with your fingers until
it only lightly touches the column tube.
3. Hold the set-screw in position with the hex
wrench, and re-tighten the hex nut.
) below the
1
).
2
9
Figure 1
Figure 2
Figure 3