Installing Harness System - Safety 1st Guide 65 User Manual

4.
5.
WARNINGS: Do not use child restraint without the seat
pad. Failure to do this can result in serious injury or death.
Cleaning Pad and Accessories
Machine wash separately with cold water on a gentle cycle. Do
not use bleach. Tumble dry separately for 10-12 minutes on
low heat. Remove immediately.
Cleaning Harness Straps
Spot clean using warm sudsy water and damp cloth.
Replace Pad
Adjust the headrest to the highest position. Starting from the
bottom, gently pull headrest pad onto headrest.
Starting from bottom of child restraint, slip pad on shell. Pull
harness adjustment strap through pad. Wrap pad around the
top of shell. Attach fastening strip. Attach elastic straps. Install
harness system, see pages 20-22.
19
Undo Fastening Strip
Behind Headrest
Remove Pad
Pull pad off the top of child
restraint, around the headrest,
and remove pad.

Installing Harness System

1. Insert Buckle's Metal
Retainer into Slot
Closest to Child
1
Buckle
2
You
3
buckle slot when child restraint is
used rear facing.
Any slot can be used when
forward facing.
2. Pull Metal Retainer
Completely Through
Pad and Shell
3. Check Buckle
Pull up on buckle to make sure it
is secured.
The buckle
4. Thread Harness Strap
With sewn end of harness strap
loop facing the buckle, thread
harness strap down through hip
harness slot.
MUST face out.
MUST use the 1st or 2nd
MUST not pull out.
20
continued on next page