Special Tools; Gauge Bar Assembly; Cutting Reel Shim; Cutting Performance Paper - Toro Greensmaster 3120 Service Manual

Special Tools

Gauge Bar Assembly

Toro Part No. 94–9010
Use gauge bar to verify height-of-cut adjustment.

Cutting Reel Shim

Toro Part No. 125–5611
Use the 0.05 mm (0.002 in) shim like a feeler gauge to
measure the gap between the reel and the bedknife during
reel adjustment.

Cutting Performance Paper

Toro Part No. 125–5610 (300 strips)
Cutting performance paper is used to test the cutting reel
performance after adjusting the reel to bedknife clearance.

Reel Drive Shaft

Toro Part No. TOR4112
Use the drive shaft for rotating the reel during cutting unit
adjustment or any time the hydraulic reel motor is removed.
Greensmaster 3120
17230SL Rev C
Special tools for servicing Toro Commercial Products are available from your
Toro Distributor. Some of these tools may have been supplied with your machine
or are available as Toro parts.
Page 7–5 DPA Cutting Units: Special Tools