Leveling the Rear Roller (continued)
Greensmaster 3120
17230SL Rev C
g226142
1.
Side plate
2.
Shoulder bolt (2 each)
Note: If the cutting unit has an optional rear roller adjustment kit (eccentric
roller shaft bushing), loosening the cutting unit side plate should not be
necessary. Adjust the rear roller by loosening the rear roller clamp fasteners
and rotating the eccentric bushing as necessary; refer to the kit Installation
Instructions for additional information.
4. Loosen, but do not remove, the two shoulder bolts that secure the side plate
to the frame on the side of the cutting unit where the rear roller is high (not
contacting the bench plate).
5. Adjust the position of the side plate so the rear roller contacts the bench plate
at both ends, making the rear roller parallel to the reel. Tighten the shoulder
bolts from 24 to 27 N∙m (210 to 240 in-lb).
6. Recheck the clearance between the rear roller and the bench plate. If
necessary, loosen and adjust second side plate on the side of the cutting unit
where the rear roller is low (contacting the bench plate).
7. Complete the cutting unit set-up and adjustment procedure.
Figure 109
3.
Rear roller
4.
Rear roller adjustment kit (optional)
Page 7–13
DPA Cutting Units: Adjustments