Toro Greensmaster 3120 Service Manual page 251

Removing the Bedbar
Greensmaster 3120
17230SL Rev C
1. Position the machine on a clean and level surface, lower the cutting units,
stop the engine, engage the parking brake and remove the key from the
ignition switch.
2. Remove the cutting unit from the machine and place the cutting unit on a
flat work surface.
3. Loosen the lock nuts (item
adjuster screw until the washers (item
4. Tip the cutting unit to expose the bedknife and support the rear of the cutting
unit; refer to Supporting the Cutting Unit when Servicing (page
5. Loosen the lock nuts (item
6. Remove the two bedbar pivot bolts, two metal washers and four plastic
washers from the cutting unit side plates.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
7. Remove the bedbar assembly from the cutting unit.
8. Inspect the nylon bushings and rubber bushings in the side plates for wear
or damage. Replace the bushings if necessary.
13 in Figure 110) on the end of each bedbar
11 in
10 in Figure 110) on each bedbar pivot bolt.
CAUTION
Page 7–15
Figure 110) are loose.
7–4).
DPA Cutting Units: Service and Repairs