Table of Contents
Advertisement
Installing the Bedbar
DPA Cutting Units: Service and Repairs
g226763
1.
Side plate
2.
Rubber bushing
3.
Nylon bushing
4.
Plastic washer (2 each)
1.
If rubber bushing was removed from either side plate, apply grease to
outside surface of new bushing and install into side plate. The bushing should
be installed flush with the inside surface of the side plate; refer to
2.
If removed, install the nylon bushings with flange facing outward.
3. Apply anti-seize lubricant to the threads and shank of each bedbar pivot
bolt; refer to
Figure
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
Note: If a new bedknife is attached to the bedbar, there may be interference
between the bedknife and the reel when installing the bedbar. Turn the
bedbar adjusting screws counterclockwise to increase bedknife clearance
if necessary.
4. Position the bedbar into the cutting unit. Make sure that the top of each
bedbar arm is between the washer (item
screw flange.
When installing the washers, make sure that the plastic washers are
positioned against the side plate.
5. Slide one metal washer and then one plastic washer onto each bedbar pivot
bolt.
6. Position one plastic washer between the bedbar and each side plate.
Figure 111
5.
Metal washer
6.
Bedbar
7.
Bedbar pivot bolt
8.
Lock nut
111.
CAUTION
11
IMPORTANT
Page 7–16
Figure
in
Figure
110) and adjuster
Greensmaster 3120
17230SL Rev C
111.
Advertisement
Chapters
Table of Contents
Troubleshooting
