Predelivery Inspection - Mercury MX 6.2 MPI Installation Manual

Predelivery Inspection

Not Check/
Applicable Adjust
CHECK BEFORE RUNNING
Drain plug in and petcocks
closed
Seawater inlet valve open
Engine mounts tight
Engine alignment
Drive unit fasteners torqued
Power trim cylinders fasteners
tight
Battery fully charged and secured
All electrical connections tight
Exhaust system hose clamps
tight
All fuel connections tight
Correct rotation propeller
(installed and torqued)
Throttle, shift and steering system
fasteners tightened properly
Throttle plates open and close
completely
Crankcase oil level
Power trim oil level
Stern drive unit oil level
Power steering fluid level
Closed cooling level
Transmission fluid level
Alternator belt tension
Seawater pickup pump belt
tension
Power steering pump belt tension
Audio warning system operation
90-864198020
Not Check/
Applicable Adjust
ON THE WATER TEST
Engine alignment (Inboards only)
Starter neutral safety
switch operation
Water pump operation
Instruments(s) operation
Fuel leaks
Oil leaks
Water leaks
Exhaust leaks
Ignition timing
Idle
FORWARD - NEUTRAL - REVERSE
gear operation
Steering operation throughout
range
Acceleration from idle rpm
WOT
specifications (in FORWARD gear)
Power trim operation
Trim tab adjustment
Boat handling
AFTER ON WATER TEST
Propeller nut torque
Fuel, oil, coolant, water and fluid
leaks
Oil and fluid levels
Apply Quicksilver Corrosion Guard to
engine package
INSTALLATION MANUAL
RPM, within specifications
RPM within
Page 77 of 77
INDEX