Engine Preparation; Engine Oil Dipstick Relocation - Mercury MX 6.2 MPI Installation Manual

Engine Preparation

1. Remove and read all tags attached to engine.
2. Remove all hardware that secures engine to shipping container.
3. Connect battery cables to engine. Be sure to observe the following:
a. Ensure that grounding stud and starter solenoid terminal are free of paint or any oth-
b. After battery cables are connected, apply a thin coat of sealant to the terminals.
Description
Liquid Neoprene
c. Be sure to slide rubber boot over positive (+) terminal after making connection.
IMPORTANT: There is a fuse located at the starter solenoid. DO NOT remove this fuse.
The positive battery cable must be connected to the same stud as the fuse.
4. Drape battery cables over top of engine to prevent interference during installation.
Engine Oil Dipstick Relocation (If Equipped)
Engine crankcase oil dipstick can be located on either starboard or port side of engine to
suit installation requirements. To move dipstick, remove dipstick from current location and
install in opposite side. Place rubber cap over the open dipstick tube.
90-864198020
er material that could cause a poor electrical connection.
b
a - Positive (+) Battery Cable
b - Starter Solenoid
c - 90 Amp Fuse - DO NOT Remove
a - Dipstick
Where Used
Battery Terminals
c
a
INDEX
INSTALLATION MANUAL
Part Number
92-25711-2
a
77001
a
77954
Page 19 of 77