Predelivery Inspection (Pdi) - Mercury T6200 TowSport Operation And Maintenance Manual

Section 8 - Checklists

Predelivery Inspection (PDI)

IMPORTANT: This checklist is for packages that are not equipped with Joystick Piloting for Sterndrive (JPS). For engine
packages equipped with JPS, use the JPS‑specific checklist, which appears in the JPS Operation Manual.
Perform these tasks before the Customer Delivery Inspection (CDI).
Check/
N/A Item
Adjust
⃞ ⃞ Service bulletin updates or repairs completed
⃞ Drain plug installed and drain valves closed
⃞ ⃞ Seawater inlet valve open
⃞ Engine mounts tight
⃞ ⃞ Engine alignment
⃞ ⃞ Drive unit fasteners tightened to specifications
⃞ ⃞ Power trim cylinders fasteners tight
⃞ Battery of proper rating, fully charged, secured, with protective covers in place
⃞ All electrical connections tight
⃞ Exhaust system hose clamps tight
⃞ All fuel connections tight
⃞ Correct propeller selected, installed, and tightened to specifications
⃞ Throttle, shift, and steering system fasteners tightened to specifications
⃞ ⃞ Test OBDM warning system and MIL (light) operation (EC models only)
⃞ Steering operation throughout range
⃞ Throttle plates open and close completely
⃞ Crankcase oil level
⃞ ⃞ Power trim oil level
⃞ ⃞ Sterndrive unit oil level
⃞ ⃞ Power steering fluid level
⃞ ⃞ Closed cooling fluid level
⃞ ⃞ Transmission fluid level
⃞ ⃞ V‑engines: serpentine belt tension
⃞ ⃞ Alternator belt tension (3.0L)
⃞ ⃞ Power steering pump belt tension (3.0L)
⃞ ⃞ SmartCraft gauges calibrated, if equipped
⃞ ⃞ Warning system operation
⃞ ⃞ Trim limit switch operation
Page 72 90-8M0128975 JUNE 2017
eng