Mercury MX 6.2 MPI Installation Manual page 52

INSTALLATION MANUAL
11. Reattach locknut and washer to cable end guide stud. Tighten until they contact, then
loosen 1/2 turn.
12. Reattach locknut and washer to cable barrel stud. Tighten until they contact. Tighten
securely, but DO NOT overtighten.
NOTE: To change cable approach direction on single or dual station installations, only the
spacers/bushings have to be switched to the opposite stud (the studs are identical).
Typical Single Cable - Forward Entry
Typical Single Cable - Rear Entry
Page 52 of 77
e
a - Cable End Guide
b - Locknut and Washer
c - Spacer (Fits over Bushings)
d - Bushings
e - Cable Barrel Location
f - Spacer (Fit over Stud)
g - Cable Barrel Stud
h - Cable End Guide Stud
a - Cable End Guide
b - Locknut and Washer
c - Spacer (Fits over Bushings)
d - Bushings
e - Cable Barrel Location
f - Spacer (Fit over Stud)
g - Cable Barrel Stud
h - Cable End Guide Stud
73589
b
e
73587
d
c
b
e
a
f
b
a
f
h
d
e
c
b
90-864198020
INDEX
g
h
71210
g
50229