Loewe bild series User Handbook Manual page 26

Table of Contents

Advertisement

Loewe bild
User handbook
Initial installation
Setting options for DVB-S reception:
If you have not selected Satellite (DVB-S/cable x) in step Connect
antenna cable(s) in the initial installation, proceed to the next section
Setting options for all types of reception.
Network
selection
If several networks are available via DVB-S, you can
decide which network you want to receive your
channels from.
Select network.
OK Confirm selection.
Proceed to next step.
Number of
satellite
antenna
cables
Select Only one antenna cable or Two antenna
cables.
OK Confirm selection.
Select here whether you have one or two satellite
antenna cables available. If two satellite antenna
cables are available, please connect them to the
ANT SAT1 and ANT SAT2 sockets of the TV set.
If only one is available, please connect it to the
ANT SAT1 socket.
Proceed to next step.
26
Select
satellite
installation
Selecting the satellite system.
OK Confirm selection.
Specify how you receive which satellite(s) (single
satellite or type of satellite system). Ask your
dealer in this regard.
The normal DVB-S settings are derived from the
selection of the location and do not need to be
changed in most cases.
Single
Reception of a single satellite via a connected LNC
satellite
(LNB).
2 satellites
Reception of two different satellites with two LNCs
on 22 kHz
(LNBs) which are connected to the TV set by a 22
switchbox
kHz switchbox.
2 satellites
Reception of two different satellites with two LNCs
on toneburst
(LNBs) which are connected to the TV set by a
switch
toneburst switch.
Max. 4
The TV set controls a DiSEqC multiswitch to which
satellites
up to four LNCs (LNBs) for different satellites are
on DiSEqC
connected.
multiswitch
DiSEqC
Select setting if the TV set is connected to a DiSEqC
one cable
single-cable system (according to EN 50494). Several
communal
Sat receivers can be connected to one Sat cable.
system
other
Select setting if the TV set is connected to a
communal
single-cable system (without DiSEqC). Several
installation
Sat receivers can be connected to one Sat cable.
Contrary to a DiSEqC one cable communal system
there are restrictions in the range of certain reception
frequencies in "common" single-cable community
systems.
Proceed to next step.
The rest of the initial installation wizard routine
depends on the selected satellite system in step Select
satellite installation.
The different satellite systems are described in the
following sections of initial installation.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bild 9Bild 7Bild 4Bild 3Bild 2Bild 1 ... Show all

Table of Contents