Table of Contents
Advertisement
Loewe bild
User handbook
System settings
Multimedia / Network
Configuration of the built-in LAN adaptor
As network operation was selected On, wired only.
IP
configuration
Select type of IP configuration.
automatic Automatic configuration of the IP address via DHCP
server or via multiple protocols according to UPnP
specification (including DHCP).
After selecting IP configuration – automatic
proceed to the network status.
manual Enter your fixed IP addresses manually.
If manual has been selected under IP configuration:
Manual IP-
configuration
Enter IP, Subnet mask, Gateway and DNS server
addresses in succession with the numerical keys
on the remote control.
Proceed to network status.
Network
status
You see the current network status again.
BACK: End of wizard.
Configuration of the built-in WLAN bridge adaptor
As network operation was selected On, wireless only.
The TV set now searches for wireless routers.
Access point
selection
After the end of the search:
Select a base channel to which the TV shall be
connected.
OK Confirm selection and proceed to the entry of the
Wi-Fi password.
If the desired access point is not found:
Mark Search again,
OK repeat search for wireless routers.
Or:
Mark Enter access point manually,
OK enter manually the SSID of the desired access
point, e.g., when the SSID of the access point is
not transferred.
WPA
passphrase
The TV set automatically detects the type of encryption
used and informs you. You will find the supported
encryption types in chapter Technical data.
If your wireless network is not encrypted: Proceed to
IP configuration.
Proceed to password entry.
Enter WLAN password.
In case of an unknown WLAN key, contact your
network administrator.
For WEP encryption
Select the WEP index,
OK proceed to IP configuration.
Select type of IP configuration.
For the further workflow of the network wizard
see left column under IP configuration.
121
Advertisement
Table of Contents
