Loewe bild series User Handbook Manual page 22

Loewe bild
User handbook
Initial installation
Network
configuration
Select option.
OK Confirm selection.
With the selection, specify whether you want to
configure the available network adaptor now.
Configure now: Make settings for network
adaptor and proxy server (see chapter System
settings,section Multimedia / Network –
Network settings).
Do not configure or configure later: Skip
network adaptor configuration.
Proceed to next step.
Connect
antennas
cable(s)
Select antenna cable.
OK Connect/disconnect antenna cable.
Select the antenna cables that are connected to
your TV.
Ahead of each selected antenna, the symbol
appears.
Cable analog:
Terrestrial (DVB-T/T2):
Cable (DVB-C):
Satellite (DVB-S/cable 1): digital channels via satellite
Satellite (DVB-S/cable 2): digital channels via satellite
IPTV:
SAT>IP:
With the connection sockets ANT SAT 1 / ANT
SAT 2 (1 , when the TV set is switched on, it is auto-
matically detected whether an antenna cable is con-
nected. The symbol appears in the menu dialogue
behind the respective antenna cable
IPTV / SAT>IP can only be selected if a network-
connection has been configured in a previous step.
Proceed to next step.
(1
The ANT SAT 2 connection is only available for set types with dual-channel (see chapter Technical data - equipment features for your TV set).
22
analogue channels via cable
digital channels via antenna
digital channels via cable
Streaming via network (In-
ternet)
digital channel via local net-
work
.
The rest of the initial installation wizard routine
depends on the selected antennas (Cable analogue,
DVB-T/T2, DVB-C, DVB-S/S2, IPTV, SAT>IP (ASTRA))
in step Connect antennas cable(s).
The different antennas/types of reception are
described in the following sections of initial installation.
Setting options for reception via Cable analog:
If you have not selected Cable analog in step Connect antenna
cable(s) in the initial installation, proceed to the next section Setting
options for reception via SAT>IP.
TV/col.
standard
The selection of a Colour standard is only required
when the Location of TV set Other country was
selected. Otherwise, the country-specific default
settings will be preset when selecting the Location
of TV set. This step will be skipped then
Select appropriate colour standard.
OK Confirm selection.
Proceed to next step.