Loewe bild series User Handbook Manual page 207

Loewe bild
User handbook
Troubleshooting
Problem
In the case of TV sets with an integrated hard
disk, this is sometimes not recognized when
switched on
General problems on connecting External
devices via an AV Input.
With Teletext different characters are dis-
played incorrectly.
There are errors on the operation of a CA
module.
The TV set does not accept CI + modules,
although these are detected in another set.
I have two CA modules in the set but never-
theless cannot simultaneously record and
view another program.
When the set is switched on, a message from
the CA module appears every time that it is
authenticated.
Possible Cause
Data errors on the hard disk can lead to this
being not recognized correctly when the TV
set is started. As a rule, the TV performs a
test of the internal hard disk itself.
To prevent damage to the hard disk, always
switch the TV set to standby first, before
disconnecting it from the power supply with
the mains switch or a switched socket strip.
The signal type is set incorrectly.
The wrong character set is set in the System
settings .
Check whether in the menu System settings
Extras Integrated features under the
menu item Hardware, PRODUCTION is
listed with CIPlus.
The setting for the rights of both CA modules
is incorrect.
Remedy/notes
The check of the hard disk can be started
manually via the menu (System settings
Control more... Hard disks
integrated one.
If this is not successful, you can via the menu
item Format integrated one completely
delete the internal hard disk.
ATTENTION: Thus all data are lost. A data
recovery is not possible in this case.
Observe the point of the data backup in the
Chapter Recordings, section Digital
Recorder – Delete manager.
Set the signal type correctly (System set-
tings Connections AV connecting
settings Signal type).
If the Signal Type is set to "Automatic" this
can lead to error recognitions in the case of
non-standardised signals. Then the standard
and signal must be adjusted according to the
specifications in the manual of the external
device.
Set the correct character set: System set-
tings Control more ...
Teletext Character set
the corresponding character set.
Switch the TV set off. Remove the CA module
from the TV set. Wait a few seconds. Reinsert
the CA module. Turn the TV set back on.
Contact your specialist dealer.
Select for the CA modules in the menu
System settings Extras
the CA Modules> Smartcard Rights the
option Same Rights.
The option must be selected for both CA
modules.
CI+ modules must be authenticated in the TV
set. Both sets thereby exchange the safety
information.
When using a CA module for the first time,
this authentication may take some time de-
pending on the module.
A shorter version of the authentication is
performed at each switch on. This is depend-
ent on the module speed and is hidden by the
start process of the TV device or possibly
leads to a message which can not be pre-
vented.
Check
Standard
Standard or
<Name of
207