Chapter 3:Installation; Install The Instrument - Raymarine ST70 Instrument Installation Manual

Chapter 3: Installation
Chapter 3: Installation
Read Planning on page 3 of this guide before you install the instrument. It helps you
to:
• Ensure you have all the correct equipment.
• Identify the install location and appropriate network connection point.
WARNING: Electrical safety
Before you make any electrical connections, ensure the power
supply is switched off and you have read the EMC installation
guidelines (see
before you begin installation.

3.1 Install the instrument

Once you are certain it is safe to proceed, follow the installation procedure below.
1. Fit cable to system connection point and route to ST70 instrument location
For SeaTalk
• Label both ends of the SeaTalk
existing ST70 instrument on your system.
• Route the cable to the location in which you plan to mount the ST70 instrument.
ng
SeaTalk backbone
ST70 instrument
For safety, your boat must be at dockside
).
page v
ng
:
ng
SeaTalk T piece
ng
SeaTalk spur
ng
cable, and attach it to the backbone or an
ng
SeaTalk
ST70 instrument
SeaTalk
SeaTalk
backbone
ST70 instrument
ng ng
spur SeaTalk spur
9
ng
T piece
D10419-1