Raymarine ST70 Instrument Installation Manual page 18

10
For SeaTalk:
• Label both ends of the SeaTalk
existing instrument or connect it to a connector block on the system.
• Route the cable to the location in which you plan to mount the ST70 instrument.
ST70 instrument
SeaTalk ng to SeaTalk cable
Note:
Check that the cable reaches the required location. If you wish to place the ST70 instru-
ment further than 400mm from the connection point you will need to purchase an appropriate
ng
SeaTalk or SeaTalk
2. Cut mounting holes
• Use the appropriate flush- or surface-mount template to cut the mounting slot for
the instrument and to drill holes for the fixing screws. See the back of this book for
templates.
• Clean and de-burr the mounting surface.
ng
-to-SeaTalk adaptor cable, and attach it to an
SeaTalk cable
ST60+ instrument
ng
-to-SeaTalk cable. See
SeaTalk cable
ST70 instrument
SeaTalk ng to
SeaTalk cable
SeaTalk 3 way block
page 7
.
ST60+ instrument
SeaTalk cable
D10421-1