Chapter 3: Installation; Planning Your Installation; Site Requirements; Transducer - Raymarine ST60 Owner's Handbook Manual

Chapter 3: Installation

Chapter 3: Installation

3.1 Planning your installation

Site requirements

This chapter describes how to install the ST60 Speed instrument, and
associated speed transducer. The transducer is fitted in the hull of the
vessel and is connected to the rear of the instrument. The actual type of
transducer depends on the type of hull in which it is to be installed.
For advice, or further information regarding the installation of this
equipment, please contact the Raymarine Product Support Department
or your own National Distributor.
Before starting the installation, spend some time considering the best
positions for both transducer and instrument, such that the Site
Requirements and the EMC Guidelines (below) are satisfied.

Transducer

Transducer
Transducer Transducer Transducer
Speed transducer dimensions
75mm (2.94in)
diameter
51mm (2.0in) 14mm
diameter (0.57in)
75mm (2.94in)
diameter
11
D4446-1