Raymarine ST70 Instrument Installation Manual page 6

• Place Raymarine equipment and cables at least 3 ft (1 m) from any equipment that
transmits, or cables that carry, radio signals from VHF radios, cables and anten-
nas. In the case of SSB radios, the distance should be increased to 7 ft. (2 m).
• Place Raymarine equipment and cables more than 7 ft (2 m) from the path of a
radar beam. A radar beam can normally be assumed to spread 20 degrees above
and below the radiating element.
• Use a power source separate from that used for engine-start. This is important to
prevent erratic behavior and data loss which can occur if the engine-start does not
have a separate battery.
• Use Raymarine-specified cables.
• Do not cut or extend cables unless doing so is detailed in the installation manual.
Remember
Where constraints on the installation prevent any of the above recommendations:
• Always allow the maximum separation possible between different items of electri-
cal equipment.
This will provide the best conditions for good EMC performance of the installation.
Suppression ferrites
Raymarine cables may be fitted with suppression ferrites. These are necessary for
correct EMC performance. Any ferrite removed during installation must be replaced
as soon as installation is complete.
Use only ferrites of the correct type, supplied by Raymarine authorized dealers.
Connections to other equipment
If Raymarine equipment is to be connected to other equipment using a cable not
supplied by Raymarine, a Raymarine suppression ferrite MUST always be attached
to the cable near the Raymarine unit.
EMC Servicing and maintenance
• Undue noise and interference may be a symptom of an EMC-related problem.
Please report any EMC-related problem to your nearest Raymarine dealer. We
use such information to improve our quality standards.
• To minimize any EMC related problems and ensure the best possible perfor-
mance form your Raymarine equipment, follow the guidelines given in the instal-
lation instructions.
Product documents
The following user documents are available to help you install and operate an ST70
instrument controller:
• ST70 Instrument Installation Guide (this document).
• ST70 Instrument Operating Guide.This is a detailed manual supplied with your
ST70 instrument. It contains important commissioning instructions.
ng
• SeaTalk
ng
SeaTalk
Reference Manual. This provides detailed information regarding
connectivity.
vi