Kenmore 110.4443 Series Use & Care Manual page 8

To avoid damage to the floor, set the washer onto
■
cardboard before moving across floor.
Move the washer to within approximately 3 ft (900 mm)
■
of the final location.
Connect Drain Hose
2.
Attach drain hose to drain port
If clamp is not already in place on elbow end of drain hose,
slide it over end as shown. Squeeze clamp with pliers and slide
black elbow end of drain hose onto black drain port and secure
with clamp.
For a laundry tub or standpipe drain, go to step 3.
For a floor drain, remove the pre-installed drain hose form
as shown in Step 4.
Install Drain Hose
3.
Place drain hose in standpipe
Drain
hose form
4.5"
(114 mm)
Place hose into standpipe (shown in picture) or over side
of laundry tub.
IMPORTANT: 4.5" (114 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
8
4.
Remove drain hose form
(Floor drain installations only)
For floor drain installations, you will need to remove the drain hose
form from the end of the drain hose. You may need additional parts
with separate directions. See "Tools and Parts."
Connect Inlet Hoses
The washer must be connected to the water faucets using
new inlet hoses (not provided). Do not use old hoses.
5.
Insert new flat washers into inlet hoses
Coupling
Insert new flat washers (not provided) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
6.
Connect inlet hoses to water faucets
Check that the washer basket is empty.
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional 2/3 turn. Repeat this step with second hose
for cold water faucet.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
Washer