In-situ RuggedReader Operator's Manual page 64

SECTION 7: CARE AND MAINTENANCE
Rugged Reader Operator's Manual
8. Insert the replacement battery pack, lining up the battery
contacts with the RuggedReader contacts.
9. Insert the tabs on the bottom of the battery
door into the case slots. Close the battery
door, making sure the door latch is in the
unlock position as the door meets the case.
10.With the door latch in the unlock position, press on the
battery door just below the door latch and slide the latch to
the left to lock it.
11. Reattach the hand strap.
Note: If you remove the battery from your device and the device is still
attached to the wall charger, the battery icon still appears on the display.
When the battery is replaced, charging resumes.
For instructions on charging a battery, see
guidelines on caring for your battery pack, see
Pack earlier in this section.
➔
Step 2 in Section 2. For
Safely Using the Battery
0055450 rev. 002 10/07
64
Press
here