Using Tdg Logger - In-situ RuggedReader Operator's Manual

SECTION 6: IN-SITU SOFTWARE
Rugged Reader Operator's Manual

USING TDG LOGGER

This application can display and log total dissolved gas and temperature
readings from In-Situ's T506 TDG probe.
1. Connect the T506 to the RuggedReader's 9-pin serial port.
2. On the RuggedReader, tap Start > Programs > TDG Logger.
The TDG Logger application will launch,
and in a moment device readings will be
displayed. Allow a few minutes for the
readings to stabilize.
To record (log) readings, you must first specify
a site. The Record button is dimmed out
(unavailable) until a site is entered.
To enter a site:
1. Tap the down arrow beside the site box.
2. Select <New>.
54
1
2
0055450 rev. 002 10/07