Replacing The Contactor On The Control Board - DEMAG DC-Com 1 Operating Instructions Manual

8.5.11

Replacing the contactor on the control board

Fig. 68
1. Unclip the contactor retaining mechanism by pressing locking tab (A) with your thumb. This carefully bends
locking tab (A) away from the contactor.
2. Then turn contactor (B) using your other hand until the mechanism no longer holds it.
3. Then unclip second locking tab (A) on the opposite side (as described in step 1 above).
4. Using your other hand, remove contactor (B) by pulling it away from the board.
The replacement contactor can only be inserted into the socket in one position. Push the contactor into contactor
socket (C) until both locking tabs (A) click into position.
92