5.10
Programming parameters with the control pendant
5.10.1
General
Parameters can be programmed to adapt the chain hoist to specific application requirements. The parameters
can be programmed using the control pendant together with the 7-segment display on the underside of the chain
hoist.
5.10.2
Meaning of the buttons
Fig. 26
1
"Lift" - Accept selection
Tab. 31
5.10.3
Meaning of the parameters
From software version SW 2.10, the following parameters can be programmed:
Display of parameter no.
0
1
2
Hoist only V2 speed
3
Lock the control pendant
Time-controlled start-up
4
(e.g. for tandem operation)
5
6
7
8
9
Tab. 32
2
Parameter name
Display of parameter value
-
-
-
-
-
-
-
"Lower" - Move to next parameter or se‐
lection value
Remark
Default
n.
V1/V2
Y.
V2
Default
n.
Control pendant is locked when several keys are actuated.
Priority is given to the first button that is pressed if the lifting and
Y.
lowering buttons are actuated together.
Default
n.
Speed-dependent start-up
Y.
Time-controlled start-up
3
"Emergency stop" - End parameter pro‐
gramming (changes are saved)
49