Chain Set Scope Of Supply - DEMAG DC-Com 1 Operating Instructions Manual

Measuring with a chain gauge on 11 chain links
Fig. 46
A DC / DK / PK new chain
B PK old chain
1 Chain gauge, part no. 836 025 44
Tab. 54
A partial load must be suspended from the load hook when measuring the chain over 11 links.
8.5.5.5

Chain set scope of supply

The chain must be replaced when the permissible chain wear limit is reached (to determine the wear limit of the
chain, see  "Checking the hoist chain", Page 74). A chain set is always supplied when a new standard
RDC/TDK chain is ordered. The chain set includes the following parts:
● Chain,
● Sprocket,
● Chain guide with plate and cap,
● Chain guide plate,
● Buffers for upper and lower hook position,
● Tube of Demag chain grease,
● Retaining ring.
The chain guide is pre-assembled, the chain is already fitted in the chain guide.
76
It does not yet need to be discarded. The chain does not yet need to be replaced.
2 The chain needs to be replaced if the measuring pin can no longer be inserted into
the 11th chain link.
3 Measuring pin
4 11. th chain link; the chain is ready to be discarded. The chain must be replaced.