Table of Contents
Advertisement
TroubleShooting
Problem
Ready Light does not light up.
Blower does not run.
Agitator does not run.
netzerotools.com
Likely Cause
Power cord connection is loose.
Power cord not connected at
machine or power source.
Emergency stop button has not
been pulled out.
Machine's blower or agitator
circuit breaker(s) has tripped.
Circuit breaker at power source
as tripped.
Electrical system may have a
loose wire.
Primary Blower's circuit breaker
needs to be in the 'on' position.
Auxiliary Blower's circuit breaker
needs to be in the 'on' position.
Variable Speed switch is in the
neutral position.
Blower contactor overload
activated.
Worn brushes in blower motor.
Blower has to be on for agitator
to come on.
Blower has not been on for 3-4
seconds.
Agitator circuit breaker needs to
be in the 'on' position.
Foreign material causing jam in
hopper.
Blower contactor overload
activated.
netzerotools.com
TURBO FORCE Instruction Manual
Remedy
Ensure appropriate power cord
connection at machine.
Ensure appropriate power cord
connection at power source.
Connect power cord.
Pull out emergency stop bottom.
Push to reset circuit breaker(s).
Reset circuit breaker.
Have the system inspected by a
qualified technician.
Place Primary Blower's circuit
breaker in the 'on' position.
Place Auxiliary Blower's circuit
breaker in the 'on' position.
Place Variable Speed switch in
either the 'off' or 'on' position.
Let system cool. If happens
often, contact Intec for settings.
Have a qualified technician
replace blower brushes or
replace blower motor.
Turn blower on.
Agitator time delay requires
blower to be on for 3-4 seconds
for agitator to activate.
Place Agitator circuit breaker in
the 'on' position.
Remove power cords, clear jam,
and restart system.
Let system cool. If happens
often, contact Intec for settings.
|
13
Advertisement
Table of Contents
