Intec Turbo Force Hp3 40009 00 Instruction Manual page 16

Problem
Insulation exiting hose is
dribbling out.
Circuit breakers need resetting
often.
Machine makes a banging noise
when agitator is operating.
netzerotools.com
Likely Cause
Heavy insulation material.
Kink in hose.
Airlock seal is worn.
Low voltage or low amperage.
Extension cord gauge is too
small.
Chain is not aligned with
sprockets.
Chain is loose.
Chain is not aligned with
sprockets.
netzerotools.com
TURBO FORCE Instruction Manual
Remedy
Push slide gate in 1-2 holes.
Turn on Auxiliary Blower.
Straighten hose.
Inspect airlock seals for cuts and
wear. Have a qualified
technician replace airlock seals.
System requires 115V / 15amp
separate circuit for agitator and
each blower.
Use a 12/3 heavy duty (i.e.
SJ300V) extension cord with
115V.
Disconnect electrical power.
Have a qualified technician
realign chain and sprockets.
Disconnect electrical power.
Have a qualified technician
adjust chain tensioner.
Adjust chain tensioner.
Disconnect electrical power.
Have a qualified technician
realign chain and sprockets.
| 15