Table of Contents
Advertisement
Problem
Machine is on, yet no material
comes out of hose.
Variable Speed is 'on' and
Variable Speed Setting is below
100%, yet still a lot of air flow.
netzerotools.com
Likely Cause
Slide gate is closed.
Insulation blockage in hose.
Blower is off.
Air pocket in hopper is
preventing insulation from
feeding into agitators.
Airlock seal is worn.
Airlock has an obstruction
preventing insulation from
exiting.
Auxiliary blower is on.
Variable Speed Setting needs to
be decreased.
netzerotools.com
TURBO FORCE Instruction Manual
Remedy
Open slide gate.
Turn system off, remove hose
and clear blockage.
Turn blower on.
Disconnect electrical power.
Redistribute insulation material
inside hopper.
Inspect airlock seals for cuts and
wear. Have a qualified
technician replace airlock seals.
Disconnect electrical power,
remove obstruction.
Place the Auxiliary Blower Circuit
Breaker in the 'off' position.
Reduce Variable Speed Setting
closer towards zero.
|
14
Advertisement
Table of Contents
