Outside Antenna Installation - Wilson Electronics PRO 70 Installation Manual

Selecting a Location for the Outside Antenna
Cell Tower
The outside antenna must be mounted at a location outside of the home or building,
where the strongest cell signal is present . This can be accomplished by using the
Wilson Signal Meter . Alternatively, a cell phone in test mode* can be used for finding
the area around the building with the strongest signal .
Mount the outside antenna as high as possible facing towards the suspected
location of the cell tower and pointing away from the expected location of the
inside antenna(s) .

Outside Antenna Installation

The antenna should be mounted as shown in Figure 1 . The mounting bracket,
included with antenna, is adjustable and will accommodate pipe diameters from
1 .25 inches to 2 inches (pipe sold separately #901117) . Mount the antenna so
that there is at least 3 feet of clearance in all directions around it . Make sure the
antenna is not pointing across your own roof or at the inside antenna as this will
cause the cell site protection circuitry to shut down the signal booster .
CORRECT INSTALLATION
Point antennas away from each other
Inside Panel
Antenna
Signal Booster
Figure 1
5
Contact Wilson Electronics Customer Support Team with any questions at 866-839-9361
or email: tech@wilsonelectronics.com.
Outdoor
Antenna
INCORRECT INSTALLATION
Never point antennas toward each other
Inside Panel
Antenna
Signal Booster
Figure 2
Mon.- Fri. Hours: 7 am to 6 pm MST.
Wide Band Antenna
Outdoor
Antenna