Adjusting The Tracking - Toro TITAN HD 1500 Series Operator's Manual

Figure 57
1. Roll bar in the upright
position
2. Roll-bar knob in the
latched position
3. Pull the roll-bar knob out
and rotate it 90 degrees.
Figure 58
1. Engaged
g036746
4. Rotate the roll-bar knob 90
degrees.
5. Roll-bar knob in the
unlatched position
6. Roll bar in the folded
position
g034593
2. Partially engaged—do not
operate with the roll bar in
this position.

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, insert a 3/16
inch hex wrench through the access hole in the
right front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
7. If the machine tracks to the left, insert a 3/16
inch hex wrench through the access hole in the
right front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
8. Drive the machine and check the full forward
tracking.
9. Repeat the adjustment until the desired tracking
is obtained.
Right control lever shown
1. Access hole on front cover
panel
45
-
EUTRAL LOCK
(Figure 59).
(Figure 59).
Figure 59
2. Tracking screw
and
AST
g035859