Adjusting The Anti-Scalp Rollers - Toro TITAN HD 1500 Series Operator's Manual

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the T
(also the 127 mm or 5 inch cutting-height
position) as shown in
3. Remove the pin from the height-of-cut bracket
(Figure 30).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
Figure 30
1. Deck-lift pedal
2. Height-of-cut holes
position.
OCK
position
RANSPORT
Figure 30.
30).
3. Height-of-cut pin
4. Transport lock knob
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
(page 22).
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
31.
1. Anti-scalp roller
2. Spacer
g036745
3. Bushing
1. Flange nut
2. Bolt
3. Bushing
27
Engaging the Parking Brake
Figure 31
4. Flange nut
5. Bolt
Figure 32
4. Anti-scalp roller
5. Spacer
Figure
g192815
g036848