Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Roll-Bar Knobs - Toro TITAN HD 1500 Series Operator's Manual

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows check the
component and circuit for a malfunction or short.
The fuses are located on the right console next to the
seat (Figure 56).
1. To replace the fuses, pull out the fuse to remove
it.
2. Install a new fuse
Figure 56
1. Fuse cover
2. Fuse holder
(Figure 56).
3. Fuel-shutoff valve
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the Roll-Bar
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
g036858
•
Check that both the mounting hardware and the
knobs are in good working condition.
•
Make sure that the knobs are fully engaged with
the roll bar in the raised position.
Note:
The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to fully
engage both knobs
44
(Figure 57 and Figure 58).