Controls System Maintenance; Adjusting The Control-Handle Position - Toro TITAN HD 1500 Series Operator's Manual

Figure 67
1. Clutch stop
6. Remove the idler spring from the post
68).
7. Remove the existing belt from the
hydraulic-pump-drive pulleys and the
engine pulley.
8. Install the new belt around the engine pulley and
the 2 hydraulic-pump pulleys
Figure 68
1. Idler pulley
2. Idler-spring post
3. Engine pulley
9. Install the clutch stop
10. Install the mower belt; refer to
(page 48).
g036860
(Figure
(Figure 68).
g036859
4. Pump-drive belt
5. Right hydraulic-pump
pulley
6. Left hydraulic-pump pulley
(Figure 67).
Belt Maintenance
Controls System
Maintenance
Adjusting the
Control-Handle Position
If the ends of the levers hit against each other, refer to
Adjusting the Motion-Control Linkage (page
Adjusting the Height
You can adjust the motion control levers higher or
lower for maximum comfort.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the hardware holding the control lever
to the control-arm shaft.
1. Bolts
2. Slotted hole
4. Move the control lever to the next set of holes.
Secure the lever with the hardware.
5. Repeat the adjustment for the opposite control
lever.
50
51).
EUTRAL
Figure 69
3. Control lever
4. Control-arm shaft
-
LOCK
g035858