After Operation; After Operation Safety; Using The Fuel-Shutoff Valve; Using The Drive-Wheel Release Valves - Toro TITAN HD 1500 Series Operator's Manual

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel and remove the key before storing
or transporting the machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Using the Fuel-Shutoff
Valve
Close the fuel-shutoff valve for transport, maintenance,
and storage (Figure 33).
Ensure that the fuel-shutoff valve is open when
starting the engine.
Figure 33
1. O position
N
g036849
g008948
2. O position
FF
Using the Drive-Wheel
Release Valves
WARNING
Hands may become entangled in the rotating
drive components below the engine deck,
which could result in serious injury.
Shut off the engine, remove the key, and allow
all moving parts to stop before accessing the
drive-wheel release valves.
WARNING
The engine and hydraulic-drive units can
become very hot. Touching a hot engine or
hydraulic-drive units can cause severe burns.
Allow the engine and hydraulic-drive units
to cool completely before accessing the
drive-wheel release valves.
The drive-wheel release valves are located on the left
and right sides underneath the engine deck.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Locate the bypass levers behind the seat, down
on the left and right side of the frame.
4. To push the machine, move both bypass knobs
rearward and lock them into place
5. Disengage the parking brake before pushing
the machine.
29
(Figure 34).