Using The Safety-Interlock System - Toro TITAN HD 1500 Series Operator's Manual

1. Roll bar in the upright
position
2. ROPS knob in the latched
position
3. Pull the ROPS knob out.
Raising the Roll Bar
Important:
Always use the seat belt with the roll
bar in the raised position.
1. Raise the roll bar to the operating position and
rotate the knobs until they move partially into
the grooves (Figure
2. Raise the roll bar to the full upright position while
pushing on the upper roll bar so that the pins
snap into position when the holes align with the
pins (Figure 9).
3. Push on the roll bar and ensure that both pins
are engaged.
Figure 9
4. Rotate the ROPS knob 90
degrees.
5. ROPS knob in the
unlatched position
6. Roll bar in the folded
position
9).
Using the Safety-Interlock
System
WARNING
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system is designed to prevent the
engine from starting unless:
•
The blade-control switch (PTO) is disengaged.
•
The motion-control levers are in the N
g036746
position.
•
The parking brake is engaged.
The safety-interlock system is also designed to shut off
the engine when the traction controls are moved from
the locked position with the parking brake engaged or
if you rise from the seat when the PTO is engaged.
The hour meter has symbols to notify the user when
the interlock component is in the correct position.
When the component is in the correct position, a
triangle lights up in the corresponding square.
1. Triangles light up when the interlock components are in the
correct position
17
EUTRAL
Figure 10
-
LOCK
g187670