Replacing The Hydraulic-Pump-Drive Belt - Toro TITAN HD 1500 Series Operator's Manual

Figure 64
1. Clutch pulley
2. Mower belt
Figure 65
1. Spring-removal tool (Toro
Part No. 92–5771)
2. Idler spring
3. Mower-deck post
11. Install the idler spring
Note:
Seat the spring ends in the anchor
grooves.
g036861
3. Spring-loaded idler pulley
4. Spring
g028279
4. Idler arm
5. Mower belt
(Figure 64).
12. Install the belt covers and the bolts attached to
them (Figure 66).
13. Install the sheet-metal guard; refer to
the Sheet-Metal Guard (page
14. Tighten the bottom bolt holding the mower-deck
curtain to the mower deck; refer to
the Mower-Deck Curtain (page
Replacing the
Hydraulic-Pump-Drive
Belt
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower belt; refer to
Mower Belt (page
4. Raise the machine and support it with jack
stands (Figure
5. Remove the clutch stop
49
Figure 66
Removing
34).
Releasing
33).
Replacing the
48).
68).
(Figure 67).
g027730