Lubricating The Cot - Ferno 24 User Manual

6.8 Lubricating the Cot

Disinfect and clean the cot before applying lubricant. Use the lubricants
designated below to lubricate the cot. Do not lubricate points marked
with the "do not lubricate" symbol.
LUBRICATION POINTS
1. Undercarriage frame joint
2. Control handle hinge
3. I-beam*


Note: The I-beam runs the length of the cot. To lubricate, tip the stretcher
on end.
LUBRICATION-FREE ITEMS
Wheel bearings (sealed)
© Ferno-Washington, Inc. / 234-0008-09 / February 2018
Maintenance
SAE 30-weight oil or EZ-1 (1-2 drops)
SAE 30-weight oil or EZ-1 (1-2 drops)
SAE 30-weight oil or EZ-1 (1-2 drops)
Do not lubricate
2
Lubricating parts that should not be lubricated allows dirt and
foreign particles to collect on those parts, resulting in damage.
Lubricate only the numbered reference points shown.
Applying Lubricant
Use a small amount of lubricant (one or two
drops). Lubricate identical points on each
side of the cot. After applying lubricant, wipe
off excess.
Do Not Lubricate
1
3
2
NOTICE
Lubricate
2
19