Operator Focus; Operator Training; Operator Height And Strength; Daily Operator Duties - Ferno 24 User Manual

2.1 Operator Training

Operator using the cot:
must read and understand this manual.
●
must have training on proper use of the cot.
●
● must have a training on mortuary-service procedures.
must have the physical ability to operate the cot.
●
must practice with the cot before using it in regular service.
●
must keep training records. For a sample training record sheet, see
●
"Training Record" on page 22.

2.2 Operator Height and Strength

When unloading the cot from a vehicle, the operator must be able to
hold the cot high enough for both sets of legs to remain clear of the
ground so they can unfold completely and lock into place.
Supporting this weight requires greater strength from short operators
than from tall operators because short operators must raise their arms
higher in relation to their shoulders (Figure 1).
If the vehicle is parked on an uneven surface, the Operator-end operator
(and any helpers) may need to lift the cot higher than normal to allow
the legs to unfold completely and lock.


Note: Use additional help as needed to lift the weight of the cot, body and
equipment. See "Using Additional Help" on page 7.

2.3 Daily Operator Duties

It is good practice for operators to check equipment at the start of each
work shift. To check the cot prior to use, follow the procedures described
in this manual:
Unload the cot from the vehicle.
●
Fold the cot to the floor or ground.
●
Raise the cot to a suitable rolling height.
●
Visually inspect the cot for readiness. See "Inspecting the Cot" on
●
page 18.
Rotate the cot in a circle to verify it rolls easily.
●
Load the cot into vehicle and secure it in the fastening system, if
●
present.
6

Operator Focus

2 - OPERATOR FOCUS
WARNING
Untrained operators can cause injury or be injured.
Permit only trained personnel to operate the cot.
Clearance from Ground
© Ferno-Washington, Inc. / 234-0008-09 / February 2018
1