Safety Information - Keysight N2894A User Manual

Safety Information

WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
Keysight N2870A-Series and N2894A Passive Probes User's Guide
To avoid personal injury and to prevent fire or damage to this product or
products connected to it, review and comply with the following safety
precautions. Be aware that if you use this probe assembly in a manner
not specified, the protection this product provides may be impaired.
Handle Probe Tips / Accessories Carefully. Some of the probe tips /
accessories are very sharp (the spring tips and ground spring, for
example). You should handle these with care to avoid personal injury.
Use Only Grounded Instruments. Do not connect the probe's ground lead
to a potential other than earth ground. Always make sure the probe and
the oscilloscope are grounded properly.
Connect and Disconnect Properly. Connect the probe to the oscilloscope
and connect the ground lead to earth ground before connecting the
probe to the circuit under test. Disconnect the probe input and the probe
ground lead from the circuit under test before disconnecting the probe
from the oscilloscope.
Observe Probe Ratings. Do not apply any electrical potential to the probe
input which exceeds the maximum rating of the probe. Make sure to
comply with the voltage versus frequency derating curve on page 9.
Keep Away From Live Circuits. Avoid open circuitry. Do not touch
connections or components when power is present.
Safety Information
7