Manual Override (Motorized Versions Only); Adjusting The Pitch - Carefree MIRAGE Service Manual

Carefree of Colorado
M O
ANUAL VERRIDE
If 110V power is not available to the vehicle, the awning can still be safely retracted using the manual
override. The bypass may be accessed from inside the case on the motor housing or from the top of the
case above the motor housing.
To use the inside bottom access: The awning must be open a
minimum of 8" to afford access to the override.
To use the top bypass access: Remove the screw and well nut
that is used to secure the end cap.
1. Chuck the 7mm hex key into a 3/8" battery powered drill.
2. Insert the hex key into the manual override on the awning.
For the top access, it will be necessary to locate the hex by
feel; it is not visible with the key inserted in the hole.
3. Operate the drill in the forward (clockwise) direction to close
the awning. Reverse the drill to open the awning.
NOTE: When using the bottom override, the awning can
only be closed within 6-8". It will be necessary to use the top
access to close the awning completely.
4. When done, return the screw and well nut to the top of the
case if removed.
A P
DJUSTING THE
NOTICE
During installation or when the pitch of the awning is adjusted, it is important that the
lead rail is parallel to the awning housing.
1. Extend the awning fully.
2. On one end, loosen the 6mm hex screw located on the spring
arm knuckle.
3. S loosen the 3/4" nut on the side of the knuckle.
LIGHTLY
4. Turn the 3/4" adjustment nut located on the bottom of the knuckle.
C raises the pitch,
LOCKWISE
NOTE: When raising the pitch, it is helpful to have a second
person lift up on the lead rail.
5. Repeat steps 2 through 4 for the other end. Note the caution
information above.
6. When the pitch adjustments are completed, tighten the 6mm
screw and the 3/4" nut on the side of the knuckle.
When the pitch is adjusted, it is necessary to adjust the angle of
the lead rail for the awning to close correctly.
7. S loosen the 3/4" nut on the side of each arm knuckle
LIGHTLY
on the lead rail.
8. Turn the 6mm hex screws of each knuckle to increase or decrease the angle of the lead rail.
INSIDE
The face of the lead rail should be parallel with the coach wall.
9. When the lead rail adjustments are completed, tighten the 3/4" nut on the side of the knuckles.
052979-301r16
Service Manual
(
MOTORIZED VERSIONS ONLY
ITCH
COUNTERCLOCKWISE
)
Top View
Bottom View
lowers the pitch.
Wall
Remove Screw
and Rubber Well Nut
to Access Manual
Overide (7mm Hex)
Manual Override
7mm Hex
Wall
3/4" Adjustment Nut
3/4" Nut
On Side of Knuckle
6mm Hex Screw
Coach Wall
Lead Rail (ref)
6mm Hex Screw
3/4" Nut
M
IRAGE
M2009
MIRAGE024
2