Standard System Adjustments; Manual Override (Motorized Only); Original Configuration; Current Configuration - Carefree Freedom RM Service Manual

Carefree of Colorado
S S
TANDARD YSTEM
M O
ANUAL VERRIDE
If power to the vehicle is not available, the awning can be safely retracted using the manual override
located on the idler (right) end of the case.
NOTE: This procedure cannot be used to extend the awning.

Original Configuration

1. Remove the plug from the right endcap and save.
2. Insert a 3/8" socket drive extension and handle into the square drive
hole inside the end cap.
3. Turn the handle clockwise until the awning is retracted.
4. Reinstall the plug

Current Configuration

1. Remove the right outer endcap and save.
2. Insert a 3/8" socket drive extension and handle into the square
drive hole inside the inner end cap.
3. Turn the handle clockwise until the awning is retracted.
4. Reinstall the outer cap.
NOTICE
After closing the awning with the manual override, the lead rail may move out from the
case 1/4" -1/2". This is normal and the awning is secure for travel until power is restored or repairs are
completed. Do not attempt to force the lead rail in with the override, serious damage can occur to the
awning.
P A
ITCH DJUSTMENT
The awning opens and closes with a steep pitch. On low profile vans, the leading edge of the awning may
hit the top of the sliding door if the door is open while extending or retracting the awning. To prevent this,
the lower limit of the pitch can be adjusted upwards.
1. Open the awning to access the adjustment screws located on the arm case knuckles.
2. Have a second person lift up on the lead rail to relieve the pressure
on the adjustment screws.
3. Using a 4mm allen wrench, turn the adjustment screw clockwise to
raise the lead rail; turn the adjustment screw counterclockwise to
lower the lead rail.
4. Repeat for each arm. Ensure that the lead rail is parallel with the
awning case.
052978-351r8
Service Manual
A
DJUSTMENTS
(M O
OTORIZED NLY
)
Case Knuckle
F
REEDOM
Remove Plug
3/8" Socket
Drive Extension
3/8" Socket
Drive Extension
Lower Raise
Pitch Adjustment Screw
RM
RMF019
Remove
Cover
RMF019a
RMF038
2