Removing The Awning; Manual Override - Carefree MARQUEE Service Manual

M
ARQUEE
R
EMOVING THE
Arm Mount
1. Open the awning
2. Remove the three screws that are through the bottom of the case.
3. Close the awning.
4. Disconnect power to the awning.
5. Disconnect the motor wires from the switch.
6. Rotate the awning upward in the awning rail.
7. Pull the wire out of the RV wall.
8. Using one person at each end of the awning, continue rotating the awning upward until the awning
mounting rail slides out of the awning rail on the RV.
M O
ANUAL VERRIDE
For models built after July 2010, a manual override is available.
M O
ANUAL VERRIDE
If power to the vehicle is not available, the awning can be safely
retracted using the manual override located on the idler (right) end of
the case.
NOTE: This procedure cannot be used to extend the awning.
1. Remove the plug from the right endcap and save.
2. Insert the override key
into the square drive hole inside the endcap.
3. Turn the handle counterclockwise until the awning is retracted.
CAUTION
After closing the awning with the manual override, the lead rail may move out from the case
1/4" -1/2". This is normal and the awning is secure for travel until power is restored or repairs are
completed. D attempt to force the lead rail in with the override, serious damage can occur to the
O NOT
awning.
1
The override key is optional and purchased separately.
10
Service Manual
A
WNING
Screw Location
1
or a 3/8" socket drive extension and handle
Screw Location
Arm Mount
Mounting
Rail
Awning
Rail
Marquee014
Carefree of Colorado
Remove Plug
3/8" Square Key
or
3/8" Socket
Drive Extension
Marquee032
052549-301r4