Operating Instructions - ADJ ENCORE BURST 100 IP User Instructions

Encore Burst 100 IP
Manual Control
and strobe rate. NOTE: NOTE: The "No DMX State" setting MUST be set to "Manual" for this
operational mode to work. Please see "No DMX State" on page 13 for more information.
1. Press either the MENU, UP, or DOWN buttons until "Manual Control" is displayed and press
ENTER.
2. Use the UP and DOWN buttons to switch between "WW LED" and "Strobe". Press ENTER to
select the function you would like to adjust.
3. Use the UP and DOWN buttons to adjust the values of the selected
Power On Time
time of the unit. This time can NOT be reset.
NOTE: The displayed time represents the total power ON running time.
1. Press either the MENU, UP, or DOWN buttons until "Information" is displayed and press ENTER.
2. Press the UP or DOWN buttons until "Fixture Life Time" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "Power On Time" is displayed and press ENTER.
4. The total power ON running time of the fixture will now be displayed. Press the MENU button to
exit.
P-On Time-R
of the unit. This running time may not be the same as the total power ON running time displayed
under "POWER ON TIME". This time CAN be reset.
NOTE: The displayed time represents the current power ON running time since the last reset.
1. Press either the MENU, UP, or DOWN buttons until "Information" is displayed and press ENTER.
2. Press the UP or DOWN buttons until "Fixture Life Time" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "P-On Time-R" is displayed and press ENTER.
4. The power ON running time of the fixture will now be displayed. Press the MENU button to exit.
P-On Time Reset
that is displayed under "P-ON TIME-R".
1. Press the either the MENU, UP, or DOWN buttons until "Information" is displayed and press
ENTER.
2. Press the UP or DOWN buttons until "Fixture Life Time" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "P-On Time Reset" is displayed and press ENTER.
4. Use the UP or DOWN buttons to set the pass code to "50" and press ENTER. The P-ON TIME-R
will now be reset to "0"
ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 15
- This function will allow you to manually adjust the LED output intensity
- With this function you are able to check the total power ON running
- With this function you are able to check current power ON running time
- With this function you can reset the current power ON running time

Operating Instructions