ADJ ENCORE BURST 100 IP User Instructions page 15

Encore Burst 100 IP
Gamma
- In this menu you are able to make gamma corrections.
1. Press either the MENU, UP, or DOWN buttons until "Gamma" is displayed and press ENTER.
2. Use the UP or DOWN buttons to adjust the gamma brightness.
3. Once you have found your desired setting press ENTER to confirm.
Tungsten
- In this menu you can activate the Tungsten Filament effect.
1. Press either the MENU, UP, or DOWN buttons until "Tungsten" is displayed and press ENTER.
2. Use the UP or DOWN buttons to toggle between "ON" and "OFF". "ON" will activate this effect
and "OFF" will deactivate it.
3. Once you have found your desired setting press ENTER to confirm.
Display
- This submenu has two functions: (1). The display can be set to turn off after 20
seconds or set to stay on at all times. (2). You can set the control panel to lock after 30 seconds.
1. Press either the MENU, UP, or DOWN buttons until "Display" is displayed and press ENTER.
2. Use the UP or DOWN buttons to switch between "Backlight" and "Display Lock". Press the
ENTER to select the setting you would like to adjust.
3. Use the UP or DOWN buttons to toggle between "ON" and "OFF" for each function.
- Backlight - "ON" will keep the display on at all times, and "OFF" will have the display turn off after
20 seconds. To "light" the display press 1 of the 4 buttons.
- Display Lock - "ON" will lock the display control after 30 seconds, and "OFF" will leave the dis
play control unlocked. To unlock the display press any 1 of the 4 buttons for at least 5 seconds.
4. Once you have found your desired settings press the ENTER button to confirm.
Service
With this function the unit can calibratated or reset to its default settings. The
-
password is "11" to access this submenu. NOTE: ONLY QUALIFIED TECHNICIANS SHOULD
PERFORM THE CALIBRATION FUNCTION.
1. Press either the MENU, UP, or DOWN buttons until "Service" is displayed and press ENTER.
2. "Pass Code" and "X" will now be displayed. "X" represents the current displayed number.
3. Use the UP and DOWN buttons to "set" the pass code and press ENTER.
4. To reset the unit to the factory settings, press the UP or DOWN buttons until "Factory Restore" is
displayed and press ENTER.
ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 14
Operating Instructions