Table of Contents
Advertisement
Encore Burst 100 IP
LED On Time
LED On time can NOT be reset.
NOTE: The displayed time represents the total LED ON time.
1. Press either the MENU, UP, or DOWN buttons until "Information" is displayed and press ENTER.
2. Press the UP or DOWN buttons until "Fixture Life Time" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "LED On Time" is displayed and press ENTER.
4. The total power ON running time of the fixture will now be displayed. Press the MENU button to
exit.
LED On Time-R
of the unit. This running time may not be the same as the total LED ON time displayed under
"LED ON TIME". This total LED ON time CAN be reset.
NOTE: The displayed time represents the current LED ON time since the last reset.
1. Press either the MENU, UP, or DOWN buttons until "Information" is displayed and press ENTER.
2. Press the UP or DOWN buttons until "Fixture Life Time" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "LED On Time-R" is displayed and press ENTER.
4. The power ON running time of the fixture will now be displayed. Press the MENU button to exit.
LED Time Reset
displayed under "LED ON TIME-R".
1. Press either the MENU, UP, or DOWN buttons until "Information" is displayed and press ENTER.
2. Press the UP or DOWN buttons until "Fixture Life Time" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "LED Time Reset" is displayed and press ENTER.
4. Use the UP or DOWN buttons to set the pass code to "50" and press ENTER. The LED ON TIME-R
will now be reset to "0"
Current
- With this function you can check the current temperature of the fixture.
1. Press either the MENU, UP, or DOWN buttons until "Information" is displayed and press ENTER.
2. Press the UP or DOWN buttons until "Fixture Temps" is displayed and press ENTER.
3. Press the UP or DOWN buttons until "Current" is displayed and press ENTER.
4. The fixtures current temperature will now be displayed. Press the UP or DOWN buttons to switch
between farenheit and celsius. Press the MENU button to exit.
ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 16
- With this function you are able to check the total LED ON time. This total
- With this function you are able to check current LED ON running time
- With this function you can reset the current LED ON time that is
Operating Instructions
Advertisement
Table of Contents
